Recent content by yamiman

Hi have a '96 vmax4 800 with PSI quads and a Digitron dt-34 egt monitor. At idle and higher cyl. #2 (2nd from right when on sled) egt always reads about 1/2 of the other cylinders. I bought a new probe, tried switching probes around, cleaned carbs and it still reads the same. Anyone have any...

Looking for upper 23t gear to fit 96 vmax4 800 (wider one)... pm or email philk@mts.net thank-you.:4fzfpi:

Hi was doing some summer maintenance on the 96' vmax 800 and noticed the molded plastic on the gas tank had let go at the gas cap latch (it is spring loaded) and I cannot latch the gas cap now. Has anyone run into this and found a repair for the latch/tank or do you have to find a whole...

Hi does anyone know if there are metal expansion rings available for the PSI quad pipe exhaust flanges? Mine have the 2 lands grooved in them but no rings (were full of hi temp sealant and that's all)...

Looking for top gear 23tooth to fit a '96 vmax4. :653:

Hi does anyone have mounting measurements/pic to mount a proaction 136" in a vmax4? Even measurements from a Warrior would be helpful... (There is a thread for mounting a 121" but we want to mount a 136"). Email is philk@mts.net thanks. Phil K.

Looking for PSI Stockblasters 800 quads or even just a set of silencers for them. :2dontknow

Saw the post with measurements for the RX-1 skid in an 800, anyone install a warrior 136" skid in a 750? Looks like it would be similar except for upper rear wheel set back further? Any info. would be appreciated thanks.

Looking for a set of PSI 800 quads to set up for trail riding...anyone? PM me plz.

Anyone know of any 800 stock pipes or Bender Twin pipes/silencer f/s?

I am looking for a nice blacked out low windshield for a '94 Vmax4...95+newer style would be nice. Also need a cover in good shape. Thank-you.