- WE HAVE SNOW!!
- Head is leaking coolant......again?
- TORS Troubles
- track racheting/HELP
- 1995 Vmax 600 max RPM
- Skis stock or aftermarket?
- need advice on GPS
- 96 vmax 4-800 engine problem
- Best place online to buy engine parts?
- What Octane# Should I Be Using?
- Vmax 4's suck
- HAPPY HOLIDAYS TO ALL 3:16
- Chaincase and gear box capicity's?
- update '97 v-4 gas gussler..
- Hard to start after some bar time??
- Clutching & Helix Questions
- Clutch Question
- PLEASE HELP!!! BACKFIRING
- M-10 on 1993 V4
- 94 Vmax4 with 121" Intalled RX1 Skid ?
- Happy Birthday Shark
- V-Max4 Slide Show.
- Still another coolant leak with the head....
- Need 800 parts
- EASY question...how many base gaskets?
- Turbocharging 96 vmax 4
- Cylinder lightly scored.....usable or not?
- SC-4 Skid
- New Shock
- Stock 800 bore?
- Putting her back together, now have a problem.
- STOCK BASE GASKET THICKNESS
- carb floats
- RX 1 / PRO ACTION SKID INSTALL
- Two Stroke Question
- ANY OF YOU GUYS USE THIS. 3:16
- silly question
- Oil...what are you using in your big Max?
- seat cover
- Base gasket questions on my 92?
- track clip size? (comoplast)
- vmax800 1996 stock suspention
- Suspention upgrade?
- Ever have problems in fresh/new powder?
- front suspension
- Happy New Year !!!
- New sled hauler!
- primary clutch
- Info on the V-Max4,
- Vmax4 development story....
- Found some amazing pre-1992 photos!!!
- tors light blinking wont idle
- TONY: SRX CLUTCH QUESTION
- RPC CDI Question
- PART NUMBER NEEDED
- 1997 Vmax 600 questions
- Iantomasi
- Primary Clutch Differances ???
- Yesterdays ride..
- what engine!
- headlight
- 137 Mains to 135, will I feel a difference?
- Oil adjustment
- 92 750 psi quads on 95 800?
- Welding crank
- air fuel adjustment
- Air filter near dash.YIKES!!
- speedometer cable
- Good read about ethanol fuel... (warning: LONG)
- NEED CLUTCH WEIGHTS
- Dressing up the Rear Suspension
- TOM PARR, MR. YAMAHA
- helix 51/45
- WHERE,s JERSEY JOE. 3;16
- secondary sheave freeplay??
- spacer plates for the reedvalves on v4800
- Hauck Blue - 5000 RPM engagement
- A VMAX 4 CLUTCH KIT NOTICE. 3:16
- OEM tall cover primary spring information
- A couple nostalgic posters from Hauck Powersports
- 97 vmax for sale
- Clutch Fitment ?
- VMAX 4 PRIMARY CAP INFO ! 3:16
- 1996 vmax 4-800 engine problem update
- Brakes faded away.
- Who sells a 43-39 helix? Belt too low also?
- 97 Moutain max questions
- need help with drive sprocket and collar
- found 94 vmax for sale
- Anybody run the radar runs @ lakes of the north?
- What's wrong with this???
- Bender 854 Avalanche WITH Pipes
- performance trail ideas???
- Pistons
- 800 run cool enough without rad?
- Happy Birthday OOC!!!!
- Stolen 1992 VMAX-4 Flint, MI
- tall cover
- OIL CONSUMPTION
- Jetting on my 92 seems off?
- different shading of red for the '96 and '97?
- Looking for Dave Lightfield from Pro-lite perf..?
- Hifax wear
- Snow on clutch causing belt slipping?
- 108exp setup for the 93?
- HOT PRIMARY
- The Snowmobiling Truth
- srx reeds
- Wrecked my 92 sled to day!
- STUCK THROTTLE
- photo??
- Tried a FX Nitro
- 95 vmax wont hook up
- TORS Disconnect
- Wiseco´s arrived - Thank´s Skinner!!
- Nearest I could figure..berrys??
- clutching or carbs?
- WHAT A DEAL. 3:16
- No Lights
- 12 source???
- ALUMINUM SKIS
- Done a little testing
- Clunk on take-off
- Handlebar Heaters resistor
- Cool air filter setup
- Need a little help on secondary disassembly.
- Lakewood's Weenie Roast
- A storm is a brew`in!!!
- More Hauck Blue Spring information.....
- World Series of Ice, Gaylord, Mi.
- SRX Suspension change??
- how long has it been?
- New ISR World Speed Record on Vmax-4!
- Vmax4 vs Hauck 760 BB
- 03 RX-1 Skid $400??
- Base gasket
- Anybody bidding on this?
- cold sieze????
- Suspention
- 1st ride after build, got to the lake.
- forcast..here we go again..
- rear suspension upgrade
- Radar run!
- Reading Plugs
- AC secondary
- clutching problems???
- cooling ???
- Yammigods 1992 clutch kit results (A+).....
- Take a look at this!
- Radar run results!!
- WE HAVE ARRIVED !! 3:16
- carb problems.
- Fuel delivery prob
- Cant find topic in 4-stroke section, maybe posted here?
- permixing 1st tank...how much can it lean out
- Rear shock 95 Vmax 600 into 92Vmax 750
- rattling noise when starting
- CARBIDES
- engine noise
- Jackshaft Bearing
- WEIGHT RIVETS
- straight cut helix
- aftermarket hoods?
- primary clutch
- 800 secondary
- Burn down
- Gear and clutch info needed.
- New to Vmax Series
- Help a guy out ...please.............
- Manual for 1994 VMAX 600?
- Adding PSI's to my 800 - clutch parts
- VMAX 800 @ Listowel Ontario Amateur Drags
- Anybody know Randy Brewer?
- Finally, I own a vmax 4
- Carb adjustment question?
- found a vmax for sale
- 1996 skid
- 96 OEM Cover
- SUSPENSION SETUP
- Quad Pipes info needed.
- 1st run on rebuild
- Happy Birthday, Roadrunner!
- Happy Birthday, AL, P!
- Should I go back to stock jets and needle positions?
- Exhaust can?
- Radar Speed Runs
- Ball Licker Speed Run
- Heat Exchanger Question
- Identify this coat.
- Having a problem...
- 99 pro action
- E-bay VM4 bearings??
- Is this normal????
- Aggressive Helix for 750 clutches?
- Aaen pipes and 42/37 helix?
- marginal snow excessory idlers
- water temp gauge
- Quick ? , not cause its kewl either.......
- Where to find a primary for a 97 - 800?
- Bender CDI question
- jets
- OFFICIAL SETUP THREAD
- still running hot
- Curt Wald on "Boosted" Quadzilla
- First ride on a '93 V-max4
- advice on buying a 1992 Vmax4..........
- EGT Options
- Dial-A-Jet
- Anyone have any insight to
- 94 vmax-4 vrs 96 vmax-4
- Long tracking Vmax4
- Spider removal?
- Wrist pin adaptors 16mm to 18mm
- Changing jets, Any tips or advice?
- rpc racing quads
- radar run clutch setup
- Transfer rods on a 97?
- Just out of curiosity.......
- Pictures of aaen quads?
- Comments about this sight and the members.
- Daman, This work for ya?
- roller rooster secondary 96 vmax-4 800
- crashed stock pipes .... anyone ?
- 22/39 Damn!!!! No Brakes???
- Track and stud length recomendations?
- 136 inch track performance?
- rear suspension .........
- U.P. Snow?
- gaylord mi 3-8-08
- Hey Tony! 3:16, we need you!
- Selling sleds and parts etc.
- WHERE IS TONY 3:16
- summer tear down
- First Ride and Almost Disaster
- Thank you Moderators
- Chaincase/Driveshaft ?
- Crank welding
- Snowmobile Expo West Yellowstone, MT
- rules
- low compression
- looking for!!!!!!!!
- BANNING
- WHY PHAZER2 MELTDOWN??
- aaen quads
- Events for 2008-2009
- watch out!
- tim bender
- Happy Birthday, opsled!
- speed
- Whose Ski's ???