Pilot Screw

[dealermotorcycles]

What do I set the pilot screw at?The manual says to set at 1 1/2 turns out.This is straight forward.However it also says do not touch,if so,count the turns.I droped in a new motor with carbs(from Montana)it had pipes on it,but not now.pilot screw was 2 3/4 turns.My old motor hads 2 turns.I don`t know if this was done at factory,or people have been in there.I live mid Canada about 680 ft.Does any one have any suggestions?
:flag_cana Mark.

[AL P]

When ya get a minute, re post this in the general forum. you`ll get alot more response`s that way. This forum is for site suggestions and help. No big deal, the general forum used to be called the "questions" forum, but sometime along the way became the "general" forum, But it still is the questions forum. LOL
Anyway, welcome to the site, and I`m sure you`ll get some answers over there at the general forum. actually, they`ll probley see it here eventually, but it`ll happen alot quicker at the "other" section.:D
AL P

EDIT: I geuss I should have mentioned that ya just click the words "general forum", instead of any of the sub-forums.

[racer7x]

I already moved it Al,, LOL

[AL P]

WOW!! you must have moved it while I was typing? LOL. Man your pretty quick racer7x! :D

[POWERSHACK]

680 FT. 1 1/4 TURNS

POWERSHACK