PDA

View Full Version : Jetting


Jabber800
08-31-2006, 07:13 PM
Anyone running bored 38 mikuni's?? I just picked up a set will be running them on a full race ported 800. howler pipes. Would like a starting point to save sometime. Plan on doing final set up on dyno but would like to be resonably close to start. Any suggestions would be appreciated!!!
Thx Dan J.
toydoc
09-01-2006, 07:54 AM
38 TMX's bored to 40mm, started at 550 mj, 6ej12-53
toydoc
09-02-2006, 07:56 AM
If your running TMX's, make sure they have "fuel pump" needle and seat.
Also need to mod the float bowl and nut (add holes) for more flow.
Jabber800
09-03-2006, 09:32 AM
The carbs I managed to get where the TM's used on cats. Anything I should know about these? Hope they will get the job done.
Thx. Dan J.