Yammiegod's 750 trail clutch setup

[bly123]

Sorry to ask you this. I know you have posted it 100 times before but I think all those posts are gone now. I am getting the blue spring, I already have the helix what primary weights do I need for your tail clutch setup for the 92 750? And do you know where I can get some? Also, do I need to grind the cover or spring on the primary? I think I remember seeing something about that before. And what spring or spring setting do I need on the secondary?

[YAMMIEGOD 3:16]

DUDE, GET 89A-10 WEIGHTS, RUN 13.9 RIVET IN BACK, 13.3 IN TIP. SET YOUR BACK CLUTCH AT B-3. WHAT HELIX YOU HAVE ? I BELIEVE YA NEED 43-37. YOU MAY NEED TO RUN 800 COVER ON PRIMARY WITH THAT HAUCK BLUE. THERE WAS SOME SPRING BIND PROBLEMS ON 750. ENGAGEMENT SHOULD BE NO LOWER THAN 4500. WATCH YOUR RPM, SHOULD BE NO MORE THAN 8350, MAY HAVE TOO FINE TUNE ! 3:16 (tony)

[bly123]

The spring I am getting is an older Hauck blue one from around 1999 or 2000. It's the light blue one. Does that one have the binding problem? I thought I read it was with the newer blue springs. I have the 43/37 upgrade helix already. Where do I buy the weights from? Does any body have a used set they want to sell? If I were to buy them new where do I buy them from? And how much do they go for?

[YAMMIEGOD 3:16]

DUDE, PULL WEIGHTS OUT OF YOUR 92, TELL ME WHAT THEY ARE. THEY SHOULD BE 89A-00. IF THEY ARE, YOU PROBLEY CAN GET AWAY WITH THESE FOR A FAST TRAIL KIT. INSTALL PRIMARY SPRING AND SET-UP SECONDARY, YOU MIGHT BE PRETTY CLOSE. ! 3:16 (tony)

[Aless750]

Yammiegod, is the optional factory yamaha 42-37 helix gonna do the job? thanks

[YAMMIEGOD 3:16]

THAT WILL WORK FINE. START IN LOCATION B-3. !! 3:16 (tony)