2000 srx suspension on 93 750

[93vmax4]

I know that there is some post out there but I couldnt find it.

Will the 2000 srx suspension bolt up or does this require bolt location changes?
If this is the one that only requires shims to center then I want to tell the guy that I want it.

Thanks to ALL for the sharing of knowledge, It is appreciated!:bowdown:

[93vmax4]

What is the recomended Lug which will still allow for studs, IE: clearance up front with out driver modification.
Thanks

[Master of Faster]

All the bolts holes have to be re-located. The front 4 redrilled, and the rear brackets moved forward about 4". Not too bad of a job though.

I ran mine with a 1" track and 1.175" Woody's studs, but I had to get the rear heat exchanger shortened a little because I tore it up.

[mark the shark]

The tech page has a 2000 SRX suspension in a '92 Vmax-4. That should get you started: http://www.vmax4.com/tech2.htm
WildMax's setup is also on the tech page: http://www.vmax4.com/tech10wildmax/proactionWildmax.htm
Shark