can my 95 Vmax-4 800 clear a 1 1/4" ripsaw track

[jwilcox555]

hey guys im looking to put a 1 1/4 track on my 95 Vmax 4 800. As of right now im set up for ice and all my local tracks seem to be running hard pack this year no ice. Also i have two 1 1/4 tracks both on arctic cats right now a 98 zr 440 and a 2001 zl 600 are these track interchangeable with my Vmax 4 or do i need to buy a new track for it. thanks

[mark the shark]

Welcome to the site! :schild27::schild27::schild27:

Here's a link for you to check out: http://www.vmax4.com/vbulletin/showthread.php?2779-Tallest-lug-track-with-stock-suspension&highlight=1+1%2F4+lug+track

Use the search box at the top of the page and search 1 1/4 lug track, you will find more information.

Shark

[fixerman519]

I have a 1 1/4 ripsaw on my 94 750, had to move mounting bolts down 3/4 inch on the rear 3bolt mount and the top Idler shaft, If that helps

[Big Bore 904]

I had a 1.25" track on my '95 a few years ago. It was one with the "finger" lugs. It worked all right under the right conditions. If you have the nylon tunnel protectors that slide on to your heat exchangers, they should go. There really isn't enough room to stud this track properly.

The lugs will touch your heat exchangers at times but it's not a big deal. This happens more if your track is loose. It usually occurs when you hit the brakes or hit a bump hard. It will clear the bulkhead easily.

Tracks for the Arctic Cat ZRs, ZLs or ZRTs fit perfectly. Good luck.