ProAction Plus Install

[tyler540]

ok guys my original intent was to do i highly detailed step by step of how i am doings things... But instead of making the install seem straight forward and exactly the same everytime, im just going to let the pictures do the talking...

here goes:
you can see in picture 5 we ran a wire thru the new front holes so we could measure easier.... also i should note we drilled all of the holes 3/16ths and then went back and drilled them bigger.... this was to lessen the margin of error when measuring center to center

[jayman54]

did you use the stock front swing arm bolt hole??? and is there a measurement front the very rear hole to the front??? i know that rear pivot arm can sit different ways... i'm in the process of puttin a 03 rx-1 skid in mine and am having hard time finding the exact info... how thick were your spacers??

[tyler540]

no i redrilled the all of the holes, the rx-1 skid has the 3 mounting holes in on the rear shaft i believe, the spacers are 1/2" 6061

you can see in the picture with the hand in it that i ran a wire through the front holes so it was easier to measure the rest... i dont remeber the measurements i used exactly but they were a combination of the measurements from other picture on this site, and from measurements on my cousins SX-V.... ill search for those pictures and edit with a link...

[tyler540]

edit: http://www.vmax4.com/vbulletin/showthread.php?7359-Proaction-in-Vmax4-Measurements&highlight=proaction+retrofit