Primary Clutch Puller Tool

[vincentblackshawdow]

Has anyone made one of these? I have found teh thread to be M18x1.50 pitch, and am thinking about making a pin to drop to the bottom of the hole in the clutch shaft. I am thinking this would work, but figured someone already has the hot ticket on this!

Thanks!

[Trying2]

Spend the 20.00 and get the right tool for the job. Trust me it will save you alot of time and patience along with maybe some extra cost due to fixing damaged threads in the crank.

[mjdevries]

I pack the hole with grease before putting the clutch puller in the hole. If you pack it solid, the clutch pops long before the tool even touches the crank. Yeah, you have to clean the grease out of the inside of the clutch, but it works very well.