Search results

  1. SamueLJackson

    Kommatti skihill 2007 dragrace, 660ft uphill

    The race is on again at next saturday, after that season is over for us (me&ike). I`ll race my old exciter under 600 cc class and ike his V4. We post pics after the race. Yammiegod any opinnions how to set up secondary at Ikes sled. Primary is with stock weights and yellow-white-yellow spring...
  2. SamueLJackson

    Weighted wiseco and orginal Ex570 piston

    And both had rings and piston pin included. Wiseco is 50 grams lighter than orginal. 335g vs 285g. I think that is quite lot?? -sami-
  3. SamueLJackson

    Need Exciter primary spring chart?

    I need spring chart where I can see preload, total force, colour codes etc. -sami-
  4. SamueLJackson

    Burned up a piston...

    I borrowed my exciter to a friend and result was that he drove too long too careful. Engine was lean at midrange because we had a cold day, about -20c. This happened even I warned him, and told him to pump trhottle when easing off. I am little bit :frech32: -sami-
  5. SamueLJackson

    Bore and Stroke info needed?

    Ok yammie freaks I need to know bore and stroke of two engines. 1. Exciter 570 -89 2. Vmax 600 -96 And if someone knows can i use vmax gyt twin pipes with Exciter engine what mods are needed??? -sami-
  6. SamueLJackson

    Mods for 03 rx-1

    4 -strokes are new to me so some help is needed. What are must mods to get more power out from rx-1 engine. Do you have any experience of Hauck or Bender exhaust systems. I am considering new (used) sled for next winter. Rx is one possibility but how much slower it is than my srx. And I dont...
  7. SamueLJackson

    Victory at our club radar run.

    Victory at club radar run 2006/2007 pics Because I`ve asked several times some tips how to get my "slow longtravel srx" run proberly I`let you know some good news. Special thanks to YAMMIEGOD, you made me beliver of srx fine engine My angle was surgered last week and I couldnt be with Ike and...
  8. SamueLJackson

    Difference between 00-01 srx 700 engine?

    Is there?
  9. SamueLJackson

    Some fine tuning to my SRX

    I installed running board enforcements,edges and covered front suspension control arms with thin aluminum tube what i found from a electrical equipment shop. -sami-:flagge_fi
  10. SamueLJackson

    YAMMIGOD,clutch help for vintage vmax.

    Ike and I are having problems with our old max. After we changed carburetors engine wont pull right under 4800 rpms and we have tried different jets zillion times.. :cussing: Stock clucth spring in our max is comet yellow/white. Were can I find preload etc values for comet 102 c springs and what...


Back
Top