GOING TAR RACING TODAY 3:16

YAMMIEGOD 3:16

YAMMIEGOD 3:16

New member
OFF TO THE TAR TODAY AT NYIRP. WE INSTALLED A 121-10.5 TRACK IN MY NEIGHBORS 700 SX. COULD THERE BE A NINE SECOND RUN THERE NOW. I,LL POST TONIGHT RESULTS. 3:16 (yammie tony)
 

MIKE, NO PICTURES YET BUT PRETTY AMAZEING BEST OF 10.28 @ 122 IN 83 DEGREE HEAT. ALOT OF 10.30ish RUNS MOST OF THE DAY. 3:16 (yammie tony)
 
Is that a stock SX? Those are some pretty good numbers. I would like to put Yamaha clutches back on both of my machines. This Polaris crap sucks.
 
MIKE NO, SLED IS PORTED ABOUT AS FARR AS IT GETS. I HAVE DONE ALL CLUTCH/CARB SET-UP. I DON,T BELIEVE THIS SLED CAN RUN 9,s. TEN TEENS YES. I ALSO AM GONNA GET THE CHANCE TO WORK WITH A 2000 SRX. VERY EXCITED ABOUT THAT. HE RUNNING 10.60s RIGHT NOW. GONNA SEE IF I CAN INPROVE THAT SOME. AND YES GO BACK TO YAMAHA STUFF. 3:16 (yammie tony)
 
Which pipes are you running on that SX Tony?? We have tried 3 different sets on ours.. I like 2!! The CPR's make super power on the big end and our Benders had great pull throughout.. I think the CPR's where a bit stronger but harder to clutch.. Our Aaen's flat out didn't compare..
 
DAN, YES BENDERS. NOW FUNNY STORIE WE HAD THIS SLED AT AFEW GRASS DRAGS LAST FALL WHERE JUSTIN FULLER FORMLY OF BENDER RACING WAS AT. HE SAID HE REMEMBERD THE SLED AND MOTOR WORK. HE ALSO STATED THESE PIPES WERE SOMEWHAT DEFFERENT THAN THE RED HEAD TRIPLE PIPES IN CATALOG. HE TOLD US TO RUN THESE PIPES AT 9000. SEEM RIGHT TO YOU ? SLED SEEMS TO RUN REAL HARD AT THAT RPM. 3:16 (yammie tony)
MIKE, ITS A 2000 SRX WITH A REAL LAZY H/C SET-UP. VERY LOW ENGAGEMENT AND BASISLY A STOCK SECONDARY SET-UP. I TRYED A SHOT IN THE DARK AND MADE A CAM CHANGE BUT IT ACTUALLY GOT WORSE. SLED IS VERY SLUGGISH OFF THE LINE. I BELIEVE IT HAS V FORCE REEDS AND A BENDER EXHAUST CAN. FIRST TWO THINGS THAT I WILL BOOT. HE SAYS ITS TRAIL PORTED. SLED STILL RUN A 10.60 @ 116. BUT I,LL SEE IF I CAN,T INPROVE HIS 60 ft AND SEE IF ET DROPS SOME. I MIGHT THROW CLUTCHES OFF MY 2002 SRX ON IT AND WING IT. 3:16 (yammie tony)
 
Last edited:
We never did alot of long pulls with the Bender pipes so I'm not sure if they would like the exta RPM's after the pipes get hot.. In shorter runs they seemed to like 8700/8800 rpm's. With a good porting job I'm betting 9000 rpm's would work great on hot pipes.. Ideal for 1/4 mile tar runs..
 
You must log in or register to reply here.


Back
Top