SRTCummins
New member
Well im back, if you guys didn't forget I had a long long thread about seizing one of my pistons and everyone got on my ass about it. but anyways as I left off a year ago:
I could not get the vmax to idle correctly, Choke off/ idles very poor, Choke on/ idles like a dream. This didn't happen before the rebuild but after the rebuild I went riding up north (Cadillac, Michigan) and my father connected the radiator hose very bad and coolant eventually escaped and the engine locked again but freed up afterwards. Drove it another 4 hours no problem till my speed went and I started getting a rather unpleasant jerking when I got on it.
I was told it was the bearing and gear, but I do not know where these are. If anybody could tell me how to hand my carbs and possibly this gear that is causing it to skip teeth I would greatly appreciate it.
Thanks
nick
I could not get the vmax to idle correctly, Choke off/ idles very poor, Choke on/ idles like a dream. This didn't happen before the rebuild but after the rebuild I went riding up north (Cadillac, Michigan) and my father connected the radiator hose very bad and coolant eventually escaped and the engine locked again but freed up afterwards. Drove it another 4 hours no problem till my speed went and I started getting a rather unpleasant jerking when I got on it.
I was told it was the bearing and gear, but I do not know where these are. If anybody could tell me how to hand my carbs and possibly this gear that is causing it to skip teeth I would greatly appreciate it.
Thanks
nick