rx1fastervmax4
New member
Would a 1995 800 primary work on 1992 750 motor? And still looking for anyone with bender quad set up for 92 vmax4. Just clutching info. THANKS...
Primary clutch??
- Thread starter rx1fastervmax4
- Start date
twostrokeaddict
Member
Yes, ive run a 800 primary on a 750 and visa versa.
lf i where in your shoes and had a 72 750 with bender quads and a 800 primary, i would leave the 800 primary as is and try
lt. A 92 750 with benders tuned properly probably puts out about around the same HP as a 800,it may not deliver it in exactly the same way/place. You may get close with the stock 800 primary, if i wasn't happy or thought there was more power on the table i would then try a aftermarket spring setup for a stock 800.
Tough call, lot of variables, tuning, wear, riding conditions etc...................
Good luck
lf i where in your shoes and had a 72 750 with bender quads and a 800 primary, i would leave the 800 primary as is and try
lt. A 92 750 with benders tuned properly probably puts out about around the same HP as a 800,it may not deliver it in exactly the same way/place. You may get close with the stock 800 primary, if i wasn't happy or thought there was more power on the table i would then try a aftermarket spring setup for a stock 800.
Tough call, lot of variables, tuning, wear, riding conditions etc...................
Good luck
Last edited:
rx1fastervmax4
New member
Thanks.. I was looking for one newer and low mileage and I thought 800 would be my best bet. I'm on my 3rd 750 primary its either cracks, or bushing failure taking them out.