steve-o
New member
Here's how its made..
I used a piece of nylon but you could use whatever you
have around like wood or steel.
Drill and tapp two holes in one end of the block far enough
apart to accomidate a standard razor blade. Then cut
out a semi-circle between the two holes you just made.
Now add washer's above the razor blade untill you have
reached the dypth of lug you want on your track.
In my case I wanted the depth of my track to be 1"
Now place the cutter over the track lugso that the bolts
are touching the bottom of the track.
Now slowly pull twardy yourself while keeping a downward
pressure on the tool.
This will cut off the remainder of the track that you don't
want leaving you with the lug hight that you require.
For me it left a 1" lugHere's a tip- Change the blade every
15-20 cuts, it makes life allot easer.
I used a piece of nylon but you could use whatever you
have around like wood or steel.
Drill and tapp two holes in one end of the block far enough
apart to accomidate a standard razor blade. Then cut
out a semi-circle between the two holes you just made.
Now add washer's above the razor blade untill you have
reached the dypth of lug you want on your track.
In my case I wanted the depth of my track to be 1"
Now place the cutter over the track lugso that the bolts
are touching the bottom of the track.
Now slowly pull twardy yourself while keeping a downward
pressure on the tool.
This will cut off the remainder of the track that you don't
want leaving you with the lug hight that you require.
For me it left a 1" lugHere's a tip- Change the blade every
15-20 cuts, it makes life allot easer.
