Search results

At the last grass drag 400' good bottom and mid but after that it slows down. It likes peeks out and flattens out. Running 9200 rpm and engagement 4300 rpm and I do run bender box. Thinking it might be in secondary clutch but not sure.

Since I can not find a 15 wide 37t lower gear looking for another set up to run in 1000ft radar runs.

Looking for 37t lower gear 93-94 vmax4. Thanks.

Found a gear that has 33 and 8bu stamped on it and 24 thats same width. 750 or 800? Wondering what years they may fit and are they worth anything?

Can't remember when I twist the sheave do i just go to next set of ramps? It says 33 deg but how the heck do you judge that.

Looking for low mileage 750 or 800 primary.

Would a 1995 800 primary work on 1992 750 motor? And still looking for anyone with bender quad set up for 92 vmax4. Just clutching info. THANKS...

Looking for gearing setup for 1000ft radar run. This is what i have. Bender quads, Bender ign box, 9 tooth no slip drivers, 192 studs, Secondary - stock helix pink-white spring in b3 holes, Primary- Hauck blue spring two shims, 89a weights with no rivets [ found only way to get rpms up at...

Just picked up set of bender quads for my 92 vmax 750. Did search only found set up for 800. Wondering about jetting? And what do you use for repacking the silencers with?

Started up my 92 vmax today and notice gas comeing from my handle bar cover. Shut off the sled and found coming from one of the vent tubes. Thinking it was a stuck float proceded to take the carbs apart and found the float not stuck and moving free. Any ideas.

Anyone have a set a quad pipes for sale? Have a stock 92 looking for a little bit more at grass drag.